Should pressure only be applied at the top of a pastry bag?
I was using a pastry bag for the first time today, and used both hands to squeeze the frosting out, applying pressure on the side and at the top of the bag. My friend said it's better to only apply pressure at the top; that's what she's seen in cooking shows.
This clashes with my understanding of the underlying physics; applying pressure at the diameter is easier, and the only negative consequence I can imagine is applying too much pressure unwittingly because of this. Is there anything else that would discourage using both hands to squeeze a pastry bag?
Best Answer
Usually you would twist the top of the bag (hint: don’t overfill) to close the bag and to get a “basic pressure level”, which will depend on the consistency of whatever is in the bag. Somewhat taut, but not leaking out of the nozzle.
Then you hold the bag closed at the twist part with thumb and forefinger, a bit like a ok-sign, just closer. Gradually closing the fingers, more sequentially that simultaneously, allows you to be very precise with the amount of pressure and thus with the flow at the nozzle. Twist the top further every once in a while to keep the bag tight.
If you are clenching the bag somewhere in the middle, you will
a) lose the “basic pressure level” after some of the batter/cream/icing was squeezed out
b) have a harder time controlling the “flow (which will for example influence the “tips” of a swirl or the top of a macaroon),
c) risk the top opening up and the filling overflowing and
d) warm up the content of the bag, which is often undesirable, changing the texture and at worst, melting it.
There’s a very good and practical reason to practice using only one hand - you need the other to maneuver the cupcakes/cookies/cake you are decorating. While for cupcakes you may get a decent enough swirl with a “two-handed clutch” method, there are more advanced skills like piping flowers on a flower nail where you really need the extra degrees of freedom.
Pictures about "Should pressure only be applied at the top of a pastry bag?"
How do you load a pastry bag?
1. Piping \u2013 is to squeeze a pastry bag in order to force frosting or other paste like mixture through the tip of the bag for the purpose of filling or decorating.How do you squeeze a piping bag?
Insert the tip: Slip the tip into the bag and place it snugly in the bottom of the bag. If you are using a couple set, insert the "inside" plastic piece into the bag first. Then secure the piping tip on the outside of the bag with the plastic ring. Screw the tip into the coupler tightly.Basic piping - how to hold and use a piping bag and tips
More answers regarding should pressure only be applied at the top of a pastry bag?
Answer 2
You apply pressure from the top and work your way down. If you squeeze from the middle, forces are applied which will force frosting in both directions including up where you don't want it to go. You use the other hand to guide the nozzle.
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Tim Douglas, Maria Orlova, Klayfe Rohden, ROMAN ODINTSOV