I want to duplicate my bread mistake!

I make all of my own bread. For just everyday use my go-to recipe is as follows:

Honey-Oat Pain de Mie

• 255g lukewarm water
• 361g AP Flour
• 85g old-fashioned rolled oats (not quick oats)
• 1 1/2 teaspoons salt
• 64g honey
• 57g melted butter
• 2 1/4 teaspoons instant yeast

I use a Pain de Mie pan like this:

Typically a loaf loaf looks like this, I made this loaf a few weeks ago:

Over half the times I have made this recipe (including yesterday), I've used my bread maker to knead the dough. I always use my (spookily accurate) digital scale to measure the ingredients; I put the bread maker insert or bowl on the scale and tare between ingredients. I always bake in the same Pain de Mie pan. Up until yesterday it has always taken 1 hour for the first rise and a half an hour for the second. I preheat the oven during the second rise, I bake for 25 minutes (per digital timer), covered, then 5 more minutes uncovered. It's as routine as brushing my teeth.

Yesterday I noticed the dough was a bit sticky when I put it into the pan after the first rise, and the first rise was done a bit quicker than usual, maybe 45-50 minutes instead of an hour. The second rise took 25 minutes instead of the usual 30.

But this is where it got really weird. The dough just went nuts in the oven. It oozed into the lips of the pan lid and onto the oven floor. You can see the shape of the loaf is odd because the dough was squeezing into the crannies.

I would just blow it off, chalk it up to human error, and assume that my next loaf will be normal. But, this bread was the best loaf of this type that I've ever made, so I want to figure out what I did wrong so I can do it again :)

I have not shopped since my last loaf, just a few days ago, and I haven't opened any new packages. So it can't be different oats, salt, butter, yeast or honey.

It is possible that I grabbed the 00 flour instead of AP (but not terribly likely, the canisters are different).

The measurements listed in the recipe by grams could have been measured incorrectly, but in this case weight errors seem less likely than spoon errors.

The least likely measurement error would be the water because I measure the water in a Pyrex measuring cup, heat it in the microwave, stick a thermometer in it until it comes down to 110F, and then pour and weigh it. So the measurement of water is redundant, and that's a pretty solid habit. I specifically remember that my water temp was normal as well.

The mistakes that I can most easily imagine are for the salt or yeast. I could have accidentally grabbed either a tsp measure or a TBS measure for the salt. I usually use a 1/2 TBS measure.

For the yeast I usually use 2 tsp measures and a 1/4 tsp measure. So 3.25 tsp would probably be the most likely error of that type.

So. With that info, what would you say is the most likely reason for this great loaf?

EDIT: It's such a good and (usually) foolproof recipe, I thought I'd share the rest of the recipe details. Use a 9" Pullman Pan, this one is great. Mix dough ingredients and then give it a 20-30 minute rest to hydrate the oats. If using a breadmaker, just run it through mixing, unplug it for 20 minutes after mixing, before kneading. After 20 minutes plug it back in, starting over, and let it run through the dough cycle. If hand kneading just knead as normal after the rest, let it rise in a warm place until doubled, about 1 hour.

Preheat oven to 350F (175C).

Give the pan and lid a bit of Pam or butter (not much, the pan is very non-stick, I do it mostly just for crust texture), shape, and place the dough in the pan. I poke across the top until it looks pretty even. Cover with plastic wrap, proof in a warm place until the dough averages just shy of an inch or 2.5cm from the top of the pan. Put the lid on and bake covered in a preheated oven for 25 minutes. Uncover and bake for another 5 minutes or until it registers about 195F (90C).

Remove loaf from pan and cool on a rack.